Products

AudioJoG(TM) Pro 5 Operations Manual

METHOD 1 - Manual Double Ended
This is the preferred method for testing a cable that is different to the previously tested one and has both ends available for plugging into the AudioJoG(TM) Pro 5.

1. Plug one end of the cable to be tested into an appropriate socket using the 'Local' half of the tester.

2. Plug the other end of the cable into an appropriate connector using the 'Remote' half of the tester.

3. Switch ON.
After a brief random display, ALL the LED's should turn ON
for a couple of seconds and then turn OFF. If this is not the
case then please check the battery, otherwise return the
AudioJoG(TM) Pro 5 for repair.

4. To start the test press and release the TEST button. On
the lower row of LED's the No1 LED will turn ON,

A single LED ON indicates that there are no connections to
that pin (Fig1).

Two or more LED's ON (either row) indicate the connection
from PIN 1 of the connector plugged into the local half to the
remote half of the tester (Fig2).

 

5. Press and release the TEST button again, the current
LED's will go out.

If there were no connections in previous step, then the remote
LED No1 will turn ON (Fig3).


Or if there were connections in the previous step, then the
local No2 LED will turn ON (Fig4).

As before if there are any other LED's ON (either row) then
they indicate the connection from the PIN 2 of the connector
plugged into the local half of the tester.



Repeat step 5 until the Remote or both SCREEN LED turn
ON (Fig5).

This is the end point for the visual test procedure,
AudioJoG(TM) Pro can not decide for you whether the results
are correct or not.

Then either:-
Press and release the TEST button to clear the display and
take you back to step 4. Or see next chapter for how to
automatically test cables against details held in memory

 

Introduction

METHOD 2 - Automatic Double Ended

METHOD 3 - Automatic Double Ended Intermittent

METHOD 4 - Manual Single Ended

METHOD 5 - Automatic Single Ended

LED/Connector pin identification table




Home - Cable tester Products - Cable Testers - Cable Testing Equipment - Technical tester data


Cablejog Logo
CableJoG Ltd   Registration No.: 4695640   VAT No.: 468 0289 22
Registered Office: 18 Browmere Drive, Croft, Warrington, Cheshire, WA3 7HT, England
Telephone: +44 (0)1925 764471   Fax: +44 (0)1925 764903
CALL US NOW!
01925 764471
  Or we'll pay for the call!
Please fill in the form below for a rapid response during normal office hours.
Name:
Tel. No.:
Email: