Products

AudioJoG(TM) Rack 8 Operations Manual

Introduction
The AudioJoG(TM) Rack 8 Cable Tester is a versatile unit that allows the user to either identify the connections within a variety of Professional Audio, Lighting & digital Network cables, Or carry out rapid comparison tests having stored known good cable details. Now with intermittent fault finding.
Cables fitted with any of the following connectors may be checked:.

The AudioJoG(TM) Rack 8 Cable Tester allows you to visually test for the following conditions:

The AudioJoG(TM) Rack 8 Cable Tester has four modes of operation:

Please read the following instructions carefully before using the AudioJoG(TM) Rack 8 Cable Tester.

Warning:
The Cables to be tested must be fully disconnected from any other equipment or electrical source. Failure to do so could result in electrical shock and permanent damage to the AudioJoG(TM) Rack 8 Cable Tester, for which the manufacturer and suppliers can accept no liability.


Getting started

The AudioJoG(TM) Rack 8 Cable Tester should be rack mounted (2U 19 inch)
using the screws and caged nuts. Next plug the small DC power plug into the back of the
AudioJoG(TM) Rack 8 and the power supply into a nearby mains outlet. NOTE: If the cabinet is
conneted to mains earth then for correct operation of the AudioJoG Rack 8 it MUST be isolated
from the cabinet by using nylon screws and nylon or plastic washers.


Test Procedure

There are 2 rows of 9 Light Emitting Diodes (LED's) corresponding to each of the 8 possible connector pins and one for the screen (or ground) connection. Checking the status of connections is made using the TEST button. Until you become familiar with the connectors pin
wiring you may wish to refer to the handy LED/Connector Identification table on the back pages.

 

Introduction

METHOD 1 - Manual Double Ended

METHOD 2 - Automatic Double Ended

METHOD 3 - Automatic Double Ended Intermittent

METHOD 4 - Manual Single Ended

METHOD 5 - Automatic Single Ended

LED/Connector pin identification table




Home - Cable tester Products - Cable Testers - Cable Testing Equipment - Technical tester data


Cablejog Logo
CableJoG Ltd   Registration No.: 4695640   VAT No.: 468 0289 22
Registered Office: 18 Browmere Drive, Croft, Warrington, Cheshire, WA3 7HT, England
Telephone: +44 (0)1925 764471   Fax: +44 (0)1925 764903
CALL US NOW!
01925 764471
  Or we'll pay for the call!
Please fill in the form below for a rapid response during normal office hours.
Name:
Tel. No.:
Email: